TEND SKIN Description
Tend Skin Liquid (effectively reduces/helps reduce/improves) the appearance of razor bumps, ingrown
hairs, and skin redness after hair removal procedures.
Visible Results May Be Seen in 24-48 Hours. Tend Skin Liquid is made with only the finest ingredients
available.
Uses
1. Reducing the appearance of:
· razor bumps
· ingrown hairs
· skin redness after all methods of hair removal
· necktie redness
2. Deodorant – underarm or foot
3. Facials – by estheticians after extraction procedures to reduce the appearance of skin bumps. At home
for overnight exfoliation.
4. Ink removal from the Skin.
Precautions
1. Do not use if you have or suspect allergies to aspirin. Symptoms include
itching, hives, redness, and difficulty breathing.
2. First time users: perform a test patch once before any hair removal procedure and once again after the
procedure. Allow 5 minutes for sensitivity reactions. If no reaction, proceed with full application.
3. This product has not been tested for use during pregnancy or nursing. Consult with physician before use.
4. Do not use within one month, unless otherwise advised, of any salon or medical strength treatments.
(Glycolic peels, AHA’s, Accutane, etc.) Do not use in combination with prescribed topical treatments without
consulting your physician.
5. Keep out of the reach of children.
6. In case of accidental ingestion, contact local poison control center.
7. Avoid eye contact. In case of eye contact, flush with running water.
8. Flammable.
9. Damaging to dyed/finished surfaces and jewelry.
10. Loofahs, shower puffs, or other scrubbing pads can increase ingrown hair/razor bump tendency from
scratching/irritating effect on skin.
11. To avoid peeling hands, apply with cotton applicator, or wear latex gloves.
Useage
1. Before and after waxing or electrolysis and only after laser hair removal, apply Tend Skin Liquid to
reduce the appearance of skin redness and minimize post-procedure skin bumping for the following day.
Note: It will typically take up to a week for an ingrown hair to form after these hair removal procedures and
Tend Skin will not be needed unless ingrown hairs remain. Sell your client a bottle of Tend Skin for use at
home to help maintain skin clarity. (See Standard Instructions.)
2. After facial extraction or facial hair removal, apply a very thin layer to reduce the appearance of skin
redness and bumping. Application of product to the entire face can be done using one end of cotton tipped
applicator.
Razor bumps (PFB): Apply twice daily: at night before retiring and again in the morning after shaving. For
those who experience irritation while shaving, apply before shaving.
Razor burn or necktie redness: Apply after shaving to thoroughly dry skin. Visible results may be seen
within a matter of hours.
Ingrown hairs: Apply to affected skin up to twice daily. Visible results may be seen within 24-48 hours.
Tweezing ingrown hairs out of the skin is unnecessary and unadvised as skin damage and increased ingrown
hair formation may result.
Electrolysis: Apply before procedure to help cleanse the skin. Apply after procedure to calm the skin and
reduce the appearance of redness within minutes.
Waxing: Apply before procedure to ease the wax pull. Apply after procedure to reduce the appearance of
redness within minutes and minimize next-day skin bumping.
Laser hair removal: Apply after procedure. Do not apply immediately before procedure.
Ingredients
Water, glycerin, emulsifying wax, ceramide 3, ceramide 6 11, ceramide 1, cholesterol, sodium lauroyl
lactylate, carbomer, xantham gum, methylparaben, propylparaben, cetearyl alcohol, propylene glycol,
isopropyl palmitate, hydrolyzed lupine protein, mineral oil, sodium PCA, behentrimonium metholsulfate,
diazolidinyl urea, sweet almond extract, citric acid